The GPU itself enjoys a nice supply of fresh air which is then exhausted right out the back of the case, so it only gets to a pretty typical 82C max. We would love to tell you noise levels, but our sound meter only goes down to 30dB and unless you stick it in the fan blades, itвЂ™s too quiet to register. After getting distracted and running a bit over our 30-minute run time, we see a CPU max temp of 76C on the CPU. We start with the glass cover, the least amount of ventilation, and likely the worst temps. We have a pretty potent 8-core system in here, so letвЂ™s close her up and see how it does thermally. There are a lot of places to stuff cables that donвЂ™t affect airflow, so you end up with a very clean build. There is a ton of space for slack cable between the GPU and the motherboard tray, so we hid most of the slack there.ДЇor as compact as the ERA is, there is a ton of space. We made sure the power supplyвЂ™s normally external switch is turned вЂonвЂ™ now before we have to open the door again later.ДЄt this point, we ran the front panel cables to the appropriate places on the board, connected the fan cables from the cooler, and cable managed everything. The Celsius S24 cooler can run the tubing right behind the power supply towards the front of the case as long as itвЂ™s all the way forward itself. ItвЂ™s at a slight angle so as not to pull too tightly on the hoses, but it wonвЂ™t hurt anything and this isnвЂ™t a windowed case anyway. You can access the rear of the CPU socket easily so we went ahead and installed the business end of the liquid cooler at this stage. We turned it so the power switch was towards the main door on the left side.ДЄfter this, we ran all of the power cables, which consist of the main 24-pin, a single 8-pin EPS, and a single GPU cable with twin 6+2 connectors for the Radeon 5700XT. We also loosely installed the SFX power supply bracket so we could hold the power supply in place and make sure the power plug cleared the fans on the cooler.Д¬orsairвЂ™s tiny SF750 power supply mounts like any other SFX power supply. We started by loosely mounting the Celsius S24 cooler with two screws in opposite corners to gauge tubing runs and power supply mounting.ДЄfter this we slapped the motherboard in with CPU and ram pre-installed and then installed the GPU.

Fractal design era reddit